ROTHENBERGER Modul Pipe 25/16 - Manual (Page 23)

ENGLISH 21
3.3 To Remove or Install the Battery Pack (Modul 25/16)
To reduce the risk of serious injury during use, follow these procedures for proper assem-
bly.
To Remove or Install the Battery Pack:
1. With dry hands, place thumb on latch and depress, then lift and pull to remove cap when
released (Figure 2).
Figure 2 - Modul 25/16 Battery Door
(2) AA-Batteries
60 min. shut off
Figure 3 - Removing/Installing Batteries for the Modul 25/16
2. Battery removal and installation (Figure 3)
To remove batteries, tilt unit slightly to slide battery(ies) into other hand.
3. Follow polarity indicators, and insert (2) AA batteries and replace battery cover and screw
(Figure 2).
3.4 Installing ROSCOPE Imager or Modul 25/16
Only one device should be connected to the unit at a time. Always make sure the unit is
off when installing or removing imagers or other accessories.
To use the ROSCOPE 1000/i2000 inspection device, the 17mm imager or the Modul 25/16 must
be connected to the handheld device. To secure connector to the handheld device, make sure
the key and slot (Figure 4 and 5) are properly aligned. Once they are aligned, hand-tighten the
knurled nut to hold the connection in place.