Vertical contact toaster, Maintenance (continued), Replacing the belt wraps (every 3–6 months) – A.J. Antunes & Co VCT-2000 9210118 User Manual
Page 12
VERTICAL CONTACT TOASTER
12
P/N 1010832 Rev. E 02/13
MAINTENANCE (continued)
INCORRECT
CORRECT
Replacing the Belt Wraps
(Every 3–6 Months)
NOTE: Depending on toaster usage and how well
they are cleaned daily, the Belt Wraps should
last between 3–6 months. Additional Belt Wraps
may be purchased from your Authorized Service
Agency.
1. Turn the power off, unplug the power cord, and
allow the unit to cool before proceeding.
2. Remove the Butter Wheel, Pan, and Heat
Shield (Figure 1) and set the Bun Thickness
Compression Knobs to 6 & 6.
3. Open both Conveyor Covers and pull the Belt
Wrap Pin out of the zipper (Figure 6).
4. Remove and discard the old Belt Wrap(s).
5. Clean both Conveyor Belt Chains just as
you would clean the Belt Wraps during Daily
Cleaning.
6. Install the new Belt Wraps around the Conveyor
Belt Chains inside the rods with the zipper flap
exposed and hanging down (Figures 7 & 8).
7. Close the Conveyor Cover(s), set the Bun
Thickness Compression Knobs back to their
normal settings and reinstall the Heat Shield,
Butter Wheel, and Pan.
CA
UT
ION
INCORRECT
CORRECT
Figure 7. Installing Belt Wrap
Figure 8. Aligning Belt Teeth
Belt Wrap
Pin
Belt Rotation
Upper Support Rod
Lower
Support Rod
CAUTION
Position the Belt Wrap UNDER the upper and
lower support rods or damage to the unit may
occur.
CAUTION
Align the ends of the Belt Wrap properly
(Figure 11) or the Belt Wrap may be damaged.
Replacing the Black and Silver Release
Sheet (Every 4–6 Weeks)
NOTE: Depending on toaster usage and on how
well it is cleaned daily, the black and silver Release
Sheet should last between 30–45 days.
1. Remove and discard the Release Sheet.
2. Lay a new Release Sheet on a clean, dry surface
and fold it in half lengthwise and gently crease it
at the fold using only your fingers (Figure 5).
3. Install the Release Sheet just as you would after
Daily Cleaning.
Fold over so
ends meet.
Press Lightly with
finger to form crease.
Figure 5. Folding the Release Sheet
Figure 6. Removing Belt Wrap
1
2
4
5 1 = 1/2"(12.7mm)
2 = 5/8"(15.9mm)
3 = 11/16"(17.5mm)
6 = 7/8"(22.2mm)
THICKNESS
THICKNESS
1
2
3
4
6
6
5
4 = 3/4"(19.1mm)
5 = 13/16"(20.6mm)
3
Interlock
Switch
Conveyor
Cover Assy.
Belt Wrap
Pin
Conveyor Belt
Chains