A.J. Antunes & Co VCT-2000 9210118 - Manual (Page 6)

VERTICAL CONTACT TOASTER
6 P/N 1010832 Rev. E 02/13
1. Remove Bun Chute from the box and install
(Figure 1).
2. Remove Butter Wheel and Pan from box. Install
the Pan over the front edge of the Heat Shield
and place the Butter Roller in Pan and engage in
to gear case (Figure 1).
IMPORTANT: Make sure Heat Shield assembly is
activating the Conveyor Interlock Switch (Figure
1). The conveyors will not rotate unless the Heat
Shield is in place and Conveyor Interlock Switch is
activated.
Unpacking
1. Remove unit and all packing materials from
shipping carton.
2. Open the included large box. It should contain
the following:
• Bun Chute (Figure 1)
• Butter Wheel and Pan (Figure 1)
• Two Release Sheets (Figure 1)
• Owner’s Manual
• Maintenance Card
• Authorized Service Agency Directory
3. Remove all shipping tape and protective
coverings from the unit and parts.
NOTE: If any parts are missing or damaged,
contact Antunes Technical Service IMMEDIATELY
at 1-877-392-7854 (toll free in the U.S.) or
630-784-1000.
Equipment Setup
Before placing the toaster into service, pay attention to
the following guidelines:
• Make sure power to the unit is off and the toaster
is at room temperature.
• Do NOT block or cover any openings on the unit.
• Do NOT immerse cord or plug in water.
• Keep cord away from heated surfaces.
• Do NOT allow cord to hang over edge of table or
counter.
• Connect the unit to the proper power supply.
Refer to the specification plate for the proper
voltage.
INSTALLATION
CAUTION
Bread may burn. Therefore toasters must not be
used near or below curtains or other combustible
walls and materials. Failure to maintain safe oper-
ating distances may cause discoloration or com-
bustion.
Assembling the Unit
NOTE: The factory has pre-installed a Release
Sheet over the Platen (Figure 1). Verify that it is
properly in place before proceeding.
CAUTION
Failure to use Release Sheets may result in dam-
age to the unit and loss of warranty coverage.