Vertical contact toaster, Operation, Operating instructions – A.J. Antunes & Co VCT-2000 9210118 User Manual
Page 8: Temperature adjustments
VERTICAL CONTACT TOASTER
8
P/N 1010832 Rev. E 02/13
1
2
4
5
1 = 1/2"(12.7mm)
2 = 5/8"(15.9mm)
3 = 11/16"(17.5mm)
6 = 7/8"(22.2mm)
THICKNESS
THICKNESS
1
2
3
4
6
6
5
4 = 3/4"(19.1mm)
5 = 13/16"(20.6mm)
3
OPERATION
Figure 3. Bun Thickness Adjustment Controls
Operating Instructions
1. Set the Bun Thickness Adjustment Controls
(Figure 3) to desired setting.
NOTE: Recommended settings are #2 for heel and
#6 for crown.
2. Turn the power on and allow the toaster to warm-
up for 30 minutes before proceeding.
NOTE: The Temperature Display (Figure 2) will flash
“LO” until the toaster reaches its preset operating
temperature. When the toaster approaches the pre-
set temperature of 600°F (315°C), “USE” appears
in the Temperature Display and the unit is ready to
toast buns. If “USE” does not appear in the win-
dow after warmup period of approximately 30 min-
utes, contact your Authorized Service Agency.
3. Slide buns across the rotating Butter Wheel with
the cut face down and drop buns into the Bun
Feeder. The cut sides of heel and crown must
face each other and slide against the Release
Sheet.
4. Toasted buns will drop into the Bun Landing Area
(Figure 2) in approximately 15 seconds.
5. Test at least 4 buns before putting the toaster into
service.
6. Turn the power off when finished toasting for the
day and proceed with the
daily cleaning as out-
lined in the Maintenance section of this manual.
Temperature Adjustments
The VCT-2000 uses a Platen Heater and two Auxiliary
Air Heaters. The Platen Heater consists of a heating
element built into the Platen to toast the cut side of the
bun. The two Auxiliary Air Heaters assist in provid-
ing additional heat to the buns. The first Auxiliary Air
Heater is located within the conveyor in the front of
the toaster. The second Auxiliary Air Heater is located
within the conveyor at the rear of the unit.
RECOMMENDED TEMPERATURES
Recommended temperature setting for the platen
heater is 600°F (315°C).
Recommended temperature setting for the auxiliary
heaters is 400°F (204°C).
NOTE: The toaster is tested and shipped with the heaters
set at the above recommended temperatures.
Bun Thickness
Adjustment Control
(See Figure 3)
Bun Landing Area
Power
Switch
Temperature
Controls
& Temperature
Display
Hi-Limit
Reset
Power
Cord
Figure 2. VCT-2000 Toaster
1
2
4
5
1 = 1/2"(12.7mm)
2 = 5/8"(15.9mm)
3 = 11/16"(17.5mm)
6 = 7/8"(22.2mm)
THICKNESS
THICKNESS
1
2
3
4
6
6
5
4 = 3/4"(19.1mm)
5 = 13/16"(20.6mm)
3
Butter Wheel
and Pan