Vertical contact toaster, Maintenance – A.J. Antunes & Co VCT-2000 9210214 User Manual
Page 11
11
VERTICAL CONTACT TOASTER
P/N 1010874 Rev. I 04/14
Daily Maintenance
Tools Required:
• Heat-resistant gloves
• Clean towels
• Multipurpose Detergent Solution
• Sanitizer Solution
1. Turn the power off, unplug the power cord, and
allow the unit to cool for 30 minutes.
2. Put on heat-resistant gloves. Remove the Bun
Feeder, Heat Shield, and Bun Chute (Figure 1).
Wipe them with a damp sanitized towel and allow
them to air dry.
3. Remove the Release Sheet and place it on a
clean, flat, dry surface.
4. Wipe the silver side of the Release Sheet with
a
clean towel dampened with Multipurpose
Detergent Solution immediately followed by a
second clean towel dampened with sanitizer and
allow it to air dry before continuing.
5. Once the silver side is dry, repeat Step 4 on the
black side of the Release Sheet.
6. Open the front Conveyor Cover and firmly wipe
the Belt Wrap from left to right and top to bottom
with a clean towel dampened with Multipurpose
Detergent Solution immediately followed by a sec-
ond clean towel dampened with sanitizer.
7. Close the front Conveyor Cover, open the rear
Conveyor Cover, and clean the Belt Wrap as
described in Step 6.
MAINTENANCE
WARNING
Turn the power off, unplug the power cord, and
allow the unit to cool down 30 minutes before
performing any service or maintenance.
CAUTION
To prevent damage to the unit, do NOT use abra-
sive cleaners on the Release Sheet or Belt Wrap.
CAUTION
Failure to use Release Sheets may result in dam-
age to the unit and loss of warranty coverage.
8. Close the rear Conveyor Cover. Reinstall the
Heat Shield, plug in the power cord.
9. Turn the unit on and allow the conveyors to
rotate and expose the uncleaned section of the
Belt Wraps. Then turn the unit off and unplug the
power cord.
10. Open the rear Conveyor Cover again and clean
the newly exposed section of the Belt Wrap in
the same manner as before. Close the Conveyor
Cover.
11. Open the front Conveyor Cover again and clean
the newly exposed section of the Belt Wrap in the
same manner as before.
12. Close the front Conveyor Cover and wipe down
the outside of the toaster with a clean, damp,
sanitized towel.
13. Install the Release Sheet by draping it over both
sides of the Platen with the crease centered on
the Platen.
NOTE: To prolong the life of the Release Sheet,
rotate from the black side to the silver side on a
daily or weekly basis.
14. Install the Bun Chute so the hooks are installed
over the lower Support Rod.
15. Install the Heat Shield with the Release Sheet
retainer clips securely over the Release Sheet
and Platen.
16. Reinstall the Bun Feeder and plug in the unit.
NOTE: Make sure the Heat Shield is activating the
Conveyor Safety Interlock Switch. The conveyors
will not rotate unless the Heat Shield is in place
and the Conveyor Safety Interlock Switch is
activated.
NOTE: Check the Release Sheet to make sure it
is not caught in the Conveyor. Additional Release
Sheets can be purchased through your Authorized
Service Agency under P/N 7000249 (3-Pack) or
7000250 (10-Pack).