A.J. Antunes & Co PS-316 9500250 - Manual (Page 10)

Pizza Station (PS-314 & PS-316)
10 P/N 1010425 Rev. F 4/08
trOublesHOOtInG
warnInG
To avoid possible personal injury and/or damage to the unit, inspection, tests, and repair of electrical
equipment should be performed by qualified service personnel. the unit should be unplugged when ser-
vicing, except when electrical tests are required. use extreme care during electrical circuit tests. live
circuits will be exposed. If the troubleshooting steps are listed, but do not solve the problem with the unit,
contact an authorized service agency.
problem possible cause corrective action
Display lights up
but the Ring Rack
does not rotate.
Door is open. close the door so that it latches against the
Microswitch.
Loose setscrew on coupling shaft. tighten setscrew.
Ring Rack is bent or damaged. straighten or replace Ring Rack.
Drive Motor Fan Blade rotation is impeded
or experiencing interference.
Inspect the Drive Motor Fan Blade and remove
any interference.
Microswitch is inoperable. contact your maintenance person or authorized
service agency.
Drive Motor is inoperable.
Loose, burnt, or broken wiring in Drive
Motor circuit.
Display does not
heat and the light
on the Display
Power switch is off.
Power cord is not plugged into the appro-
priate outlet.
Plug the power cord into the an appropriate
outlet.
circuit breaker is off or has been tripped. Reset the circuit breaker. contact your mainte-
nance person or authorized service agency if it
trips again.
Display Power Switch is inoperable. contact your maintenance person or authorized
service agency for service.
Loose, burnt, broken wiring in display
circuit.
Display does not
heat but the light on
the Display Power
switch is on.
Display Thermostat is inoperable. contact your maintenance person or authorized
service agency for service.
Display Heater is inoperable.
Loose, burnt, broken wiring in display
heater circuit.
Display area tem-
perature is too high,
too low, or uneven.
Display Thermostat is inoperable. contact your maintenance person or authorized
service agency for service.
Display area is very
dry.
the Multipurpose tray does not contain
water.
add water as needed to the Multipurpose tray
to add some humidity to the display area.
One or more dis-
play lights do not
light up.
One or more bulbs are burnt out. Replace bulbs as needed.
One or more inoperable bulb socket. contact your maintenance person or authorized
service agency for service.
Loose, burnt, broken wiring in lighting
circuit.
Oven does not heat
and the light on the
Oven Power switch
is off.
Oven Power switch is inoperable. contact your maintenance person or authorized
service agency for service.
Loose, burnt, broken wiring in oven circuit.