A.J. Antunes & Co PS-316 9500250 - Manual (Page 7)

7
Pizza Station (PS-314 & PS-316)
P/N 1010425 Rev. F 04/08
figure 1. pizza station components
unpacking
1. Remove unit and all packing materials from
shipping carton.
2. Open the large box. Remove all packing materi-
als and protective coverings from the unit and
parts.
nOte: If any parts are missing or damaged, con-
tact the factory immediately at 1-800-253-2991 (toll
free in the u.s. and canada) or 630-784-1000.
3. Remove the Pizza Rack by pushing down on the
top arm and sliding it out of the shaft coupling
(Figure 1).
4. Remove the Multipurpose tray, crumb tray, and
Pizza baking Rack (Figure 1).
5. Wash all components in soap and water. Wipe all
surfaces of the unit with a hot damp cloth.
nOte: Do nOt use a dripping wet cloth. wring
out before use.
6. Reinstall the Multipurpose tray over the heater.
7. Reinstall the Ring Rack by placing the bottom
end onto the Pivot Pin and pushing down on
the top arm while positioning it into the shaft
coupling (Figure 1). slowly turn the rack until it
snaps into place.
8. Reinstall the baking Rack into the oven so it is
level on all four pins. the baking Rack can be
adjusted up or down to suit baking needs.
9. Reinstall the crumb tray.
equipment setup
When placing the unit into service, pay attention to the
following guidelines.
• Make sure power to the unit is off and the unit is
at room temperature.
• Do NOT block or cover any openings on the unit.
• Do NOT immerse cord or plug in water.
• Keep cord away from heated surfaces.
• Do NOT allow cord to hang over edge of table or
counter.
• Place unit on a sturdy, level table or work surface.
• Ensure that the line voltage corresponds to the
stated voltage on the unit specification label.
• Turn off the power switch before connecting the
unit to the power supply.
InstallatIOn
cautIOn
all electrical connections must be in accordance
with local electrical codes and any other appli-
cable codes.
warnInG
electrIcal sHOcK HazarD. faIlure tO
fOllOw tHe InstructIOns In tHIs manual
cOulD result In serIOus InJurY Or DeatH.
• Electrical ground is required on this appliance.
• Do NOT modify the power supply cord plug. If
it does not fit the outlet, have a proper outlet
installed by a qualified electrician.
• Do NOT use an extension cord with this unit.
• The unit should be grounded according to local
electrical codes to prevent the possibility of
electrical shock. It requires a grounded recep-
tacle with separate electrical lines, protected by
fuses or circuit breaker of the proper rating.
• Check with a qualified electrician if you are
unsure if the appliance is properly grounded.
pizza
rack
multipurpose
tray
pizza baking
rack
crumb tray
top arm
shaft
coupling
pivot
pin