Operation – A.J. Antunes & Co PS-316 9500250 User Manual

Page 8

Advertising
background image

Pizza Station (PS-314 & PS-316)

8

P/N 1010425 Rev. F 4/08

General

the pizza station oven is designed to operate at a ther-

mostatically controlled temperature of approximately

350°F (177°c). the oven is left on between baking

cycles. testing to determine correct baking time may

be necessary to compensate for the fixed oven

temperature.

ImpOrtant: we recommend baking a few test

pizzas to determine the best baking time for your

product before the first day of service.

Operating Instructions

1. Turn the Display Power Switch on and close the

door. the display lights will come on and the

rack will rotate. the display area will start to heat.

2. the unit may be operated with or without water.

to add some humidity to the display area, fill the

Multipurpose tray (Figure 1) with water. Refill as

needed.

nOte: surrounding surfaces are hot. take caution

when adding water to the unit.

3. turn the Oven Power switch (Figure 2) on and

allow approximately 20 minutes for the oven to

reach operating temperature.

4. Place a pizza into the oven and close the door.

5. Turn the Timer Knob (Figure 2) to the desired set-

ting. the numbers indicate approximate baking

time in minutes. Follow the manufacturer’s rec-

ommended setting for baking the pizza. adjust

the Timer Knob to obtain more or less baking

time as required.

NOTE: The Baking Rack can be adjusted up or

down to obtain desired browning of the top or

bottom of the pizza. move the rack up for browner

top or down for browner crust.

figure 2. controls

OperatIOn

6. turn the timer Power switch (Figure 2) on. after

the pizza bakes for the set amount of time, an

audible signal (buzzer) sounds. turn off timer

Power switch to cancel the buzzer.

7. Place an appropriately sized pizza pan on the

counter. Open the oven door and remove the

pizza using a peel. if the pizza is to be served in

slices, cut the pizza before placing it on the pan.

ImpOrtant: pizza slices will not hold their

appearance as well as a whole, unsliced pizza.

8. Open the display area door and place the pizza

pan onto the Ring Rack. the rack will stop rotat-

ing when the door is opened. close the door.

9. check the temperature in the display area by

observing the thermometer located on the corner

support. A Display Thermostat maintains the

display area temperature at approximately 184°F

+/- 5°F (81°

87°c).

Display power switch

Oven power switch

timer Knob

timer power switch

Advertising
This manual is related to the following products: