A.J. Antunes & Co PS-316 9500250 - Manual (Page 9)

9
Pizza Station (PS-314 & PS-316)
P/N 1010425 Rev. F 04/08
warnInG
Do nOt use a sanitizing solution or abrasive
materials. the use of these may cause damage to
the stainless steel finish.
maIntenance
cautIOn
chlorides or phosphates in cleaning agents (e.g.
bleach, sanitizers, degreasers, or detergents)
could cause permanent damage to stainless steel
equipment. the damage is usually in the form of
discoloration, dulling of metal surface finish, pits,
voids, holes, or cracks. this damage is perma-
nent and nOt covered by warranty. the following
tips are recommended for maintenance of your
stainless steel equipment:
• Always use soft, damp cloth for cleaning, rinse
with clear water and wipe dry. when required,
always rub in direction of metal polish lines.
• Routine cleaning should be done daily using
soap, ammonia detergent, and water.
• Stains and spots should be removed using a
vinegar solution.
• Finger marks and smears should be rubbed off
using soap and water.
• Hard water spots should be removed using a
vinegar solution.
warnInG
turn the power off, unplug the power cord, and
allow the unit to cool down before performing any
service or maintenance.
cleaning
the unit requires a minimum amount of maintenance.
to ensure proper operation, clean the unit at the end of
each serving day.
1. turn off all switches.
2. unplug the power cord from the electrical outlet
and allow the unit to cool to room temperature
before proceeding.
3. Remove the Pizza Rack by pushing down on the
top arm and sliding it out of the shaft coupling.
Remove the Multipurpose tray, crumb tray, and
Pizza baking Rack.
4. Wash all components in soap and water. Wipe all
surfaces of the unit with a hot damp cloth.
5. if necessary, use an oven cleaning product to
remove baked-on deposits inside the oven.
6. Wash glass surfaces, inside and out, with a clean
cloth.
7. Wash and dry all surfaces of the unit.
nOte: Do nOt use a dripping wet cloth. wring
out before use.
8. Reinstall the Multipurpose tray over the heater
and reinstall components in unit.
9. install the Ring Rack by placing the bottom end
onto the Pivot Pin and pushing down on the top
arm while positioning it into the shaft coupling.
slowly turn the rack until it snaps into place.
10. Reinstall the baking Rack into the oven so it is
level on all four pins. the baking Rack can be
adjusted up or down to suit baking needs.
11. Reinstall the crumb tray.
lamp replacement
1. turn off all switches.
2. unplug the power cord from the electrical outlet
and allow the unit to cool to room temperature
before proceeding.
3. Remove the top cover (Figure 3).
4. Replace the Lamp(s) (Figure 3).
5. Reinstall the top cover.
figure 3. lamp replacement
top cover
lamps