A.J. Antunes & Co PS-316 9500250 - Manual (Page 4)

Pizza Station (PS-314 & PS-316)
4 P/N 1010425 Rev. F 4/08
in addition to the warnings and cautions in this manual,
use the following guidelines to safely operate the unit:
• Read all instructions before using equipment.
• For your safety, the equipment is furnished with
a properly grounded cord connector. Do NOT
attempt to defeat the grounded connector.
• Install or locate the equipment only for its
intended use as described in this manual.
• Do NOT operate this equipment if it has a dam-
aged cord or plug, if it is not working properly, or
if it has been damaged or dropped.
• This equipment should be serviced by qualified
personnel only. contact the nearest authorized
service agency for adjustment or repair.
• Do NOT block or cover any openings on the unit.
• Keep cord away from heated surfaces.
• Do NOT allow cord to hang over edge of table or
counter.
the following warnings and cautions appear
throughout this manual and should be carefully
observed.
• Turn the power off, unplug the power cord,
and allow the unit to cool down before per-
forming any service or maintenance.
• The procedures in this chapter may include
the use of chemical products. these chemi-
cal products will be highlighted with bold
face letters followed by the abbreviated Hcs
(Hazard communication standard). see
Hazard communication standard manual for
the appropriated material safety Data sheets
(msDs).
• The unit should be grounded according to
local electrical codes to prevent the possibil-
ity of electrical shock. It requires a grounded
receptacle with separate electrical lines,
protected by fuses or circuit breaker of the
proper rating.
• All electrical connections must be in accor-
dance with local electrical codes and any
other applicable codes.
• warnInG electrIcal sHOcK HazarD.
faIlure tO fOllOw tHese InstructIOns
cOulD result In serIOus InJurY Or
DeatH.
- electrical ground is required on this unit.
- Do nOt modify the power supply cord
plug. If it does not fit the outlet, have a
proper outlet installed by a qualified
electrician.
- Do nOt use an extension cord with this
appliance.
- check with a qualified electrician if you are
unsure if the unit is properly grounded.
• this equipment is to be installed to com-
ply with the basic plumbing code of the
building Officials and code administration,
Inc. (bOca) and the food service sanitation
manual of the food and Drug administration
(fDa).
• Do NOT immerse cord or plug in water.
• Do NOT clean this appliance with a water jet.
• Do NOT use a sanitizing solution or abrasive
materials. the use of these may cause dam-
age to the stainless steel finish.
• Do NOT use corrosive chemicals in this
equipment.
• Chlorides or phosphates in cleaning agents
(e.g. bleach, sanitizers, degreasers, or deter-
gents) could cause permanent damage to
stainless steel equipment. the damage is
usually in the form of discoloration, dulling
of metal surface finish, pits, voids, holes, or
cracks. this damage is permanent and nOt
covered by warranty.
• The following tips are recommended for main-
tenance of your stainless steel equipment:
- always use a soft, damp cloth for clean-
ing, rinse with clear water, and wipe dry.
when required, always rub in direction of
metal polish lines.
- routing cleaning should be done daily
with soap, ammonia detergent, and water.
- stains and spots should be sponged
using a vinegar solution as required.
- finger marks and smears should be
removed using soap and water.
- Hard water spots should be removed
using a vinegar solution.
ImpOrtant safetY InfOrmatIOn