AccuTemp ACCU-STEAM GAS GRIDDLE - Manual (Page 11)

AT2T-3238-1 Rev. C ACCU-STEAM GAS GRIDDLE OWNERS MANUAL Page 5/29
INSTALLATION (cont.)
Provisions should be incorporated in the design of the kitchen, to ensure an
adequate supply of fresh air for proper combustion and ventilation. When installing,
never enclose the bottom of the unit with a raised curb or any other construction that
would obstruct the flow of air into the unit.
UNPACKING
This appliance was carefully inspected before shipment from the factory. The
transportation company assumes full responsibility for safe delivery to the customer
until customer acceptance of this packaged appliance.
GRIDDLE LIFTING
Griddles are heavy enough to require additional manpower or powered assistance
when installing or moving the griddle.
LEVELING
The griddle must be installed in a level condition. An out-of-level condition may
cause damage to the griddle and damage of this type is not covered by the limited
warranty. Use a spirit level resting on the griddle surface to ensure it is level front-to-
back and left-to-right.
If this is a counter-top installation, the griddle must be set and leveled
using the adjusters on the legs before installing the (4) rubber foot tips
provided with the griddle. The installation of the 4 rubber tips will keep the griddle
from sliding on the counter-top under normal use.
If your griddle is attached to an AccuTemp stand with casters, ensure that the floor
surface is level and place the two locking casters to the “on” position.
STAND INSTALLATION
All griddle installations utilizing an AccuTemp stand with casters, shall be made with
a connector that complies with the Standard for Connectors for Movable Gas
Appliances, ANSI Z21.69 or CAN/CGA 6.16 and a quick disconnect device that
complies with the Standard for Quick Disconnect Devices for Use With Gas Fuel,
ANSI Z21.41 or CAN 1-6.9 .
CAUTION
This appliance is heavy. For safe handling, the installer should obtain help
as needed or employ appropriate material handling equipment to remove
the appliance from the skid and move into its final destination.