elektraLite eyeBall RGBWA (5-in-1) User Manual

Page 2

Advertising
background image








1. Unpacking

Thank you for choosing the ElektraLite eyeBall RGBWA (5-in-1) fixture. For your own safety, please
read this manual before installing the device. This manual covers important information on installation
and applications. Please keep this manual for future reference.

ElektraLite eyeBall (5-in-1)

wash fixture uses 7 high powered 12 watt quad leds, derated to run at 10

watts in a balanced arrangement giving incredible output. Please unpack the ElektraLite eyeBall
(5-in-1)

carefully and check whether it was damaged in shipping.

The following item should be in the box with the fixture:-

2 part yoke

2 knobs for yoke

1 DMX 5 pin cable

1 Turnaround 3 to 5 pin cable
1 Turnaround 5 to 3 pin cable

1 IEC power cable

1 IEC jumper cable (for daisy chaining the power between fixtures)


Please handle the fixture with care at all times. Do not drop. Do not hit the front lens assembly.

2. Safety Instructions.

This device has left the factory in perfect condition. In order to maintain this condition and to ensure a
safe operation, it is absolutely necessary for the user to follow the safety instructions and warning notes
written in this user manual. ElektraLite eyeBall (5-in-1) is a high voltage fixture. Be careful when
dealing with high voltages.
Please read this manual. If you do not read this manual and damages occur to the ElektraLite
eyeBall (5-in-1), then it could void the warranty.
During shipping, the ElektraLite eyeBall (5-in-1) may have been exposed to high temperature
changes or humidity changes. So, as a precaution, do not switch the ElektraLite eyeBall (5-in-1) on
immediately. Condensation can damage the ElektraLite eyeBall (5-in-1) so leave the ElektraLite
eyeBall

(5-in-1) switched off until it has reached room temperature. The ElektraLite eyeBall (5-in-1) is

an INDOOR operational fixture. Do not operate this fixture outdoors or anywhere there is high
humidity.

The electric connection must carry out by a qualified person and it is absolutely essential that the
ElektraLite eyeBall

(5-in-1) be grounded. So under no circumstances break off the ground pin on the

Edison plug or use the fixture where a ground is not present. A ground pin, like the fuse for the
ElektraLite eyeBall (5-in-1)

is there for safety.


Always disconnect the ElektraLite eyeBall (5-in-1) from the power source, when the fixture is not in
use or before cleaning it. Only unplug ElektraLite eyeBall (5-in-1) from the power source holding onto
the Edison plug. Never pull out the Edison plug out by just pulling on the power cord itself.

Please keep the ElektraLite eyeBall (5-in-1) away from children and the general public. Please be
intelligent and use common sense when operating the ElektraLite eyeBall (5-in-1).

Advertising