elektraLite eyeBall RGBWA (5-in-1) - Manual (Page 3)

3. General Guidelines.
ElektraLite eyeBall (5-in-1) is a lighting fixture for professional use on stages, in clubs, theatres,
churches etc.
ElektraLite eyeBall
(5-in-1) should only be operated at between 120 to 240 volts and only indoors.
ElektraLite eyeBall (5-in-1) should not be operated 24/7 (24 hours a day; 7 days a week). ElektraLite
eyeBall (5-in-1) needs operation breaks to ensure that it will work for a long time without problems.
Please do not shake the ElektraLite eyeBall (5-in-1) and avoid using brute force when installing or
operating it.
Please read this below. It is important to understand and realize the following:-
The lens encapsulates each of the leds. This way the maximum output is attained. However this means
that, if the fixture is dropped or the front lens assembly is struck, then it is possible for leds to be
crushed. So please exercise care and attention. This is not a par64 that can be abused at will!
When choosing the location to install the ElektraLite eyeBall (5-in-1), please make sure that it is not
exposed to extreme heat, moisture or dust and never install it outdoors. Make sure that the fixture has a
good amount of free space around it for air flow. Do not install it in a confined space or have insulation
around the fixture. The minimum distance between the ElektraLite eyeBall (5-in-1) and the illuminated
surface must be more than 3 feet.
Always mount the ElektraLite eyeBall (5-in-1) with an appropriate safety cable.
Operate the ElektraLite eyeBall (5-in-1) only when you are familiar with the features on the fixture. Do
not permit operation by persons not qualified.
All modifications to the ElektraLite eyeBall (5-in-1) will invalidate the warranty. There are
absolutely no exceptions.
If ElektraLite eyeBall (5-in-1) is operated in any way different to the one described in this manual,
ElektraLite eyeBall (5-in-1)
maybe damaged and the guarantee will be void.
4. Installation
Please ensure that the ElektraLite eyeBall (5-in-1) is hung using the appropriate "C" clamp or half
cheeseboro. A safety chain or cable should also be used as a secondary point of holding the fixture in
case the clamp comes loose. Never hang the fixture without a safety chain or cable. Make sure the Gel
frame (Gel holder) is clipped into position correctly and cannot come loose.
If you are not qualified or have any doubts about hanging the ElektraLite eyeBall (5-in-1) then do NOT
hang it.
Do not clamp the safety cable to the U bracket or clamp. That is not a secondary safety point.
A secondary safety point is any point that will adequately hold the ElektraLite eyeBall (5-in-1) if the
"C" clamp or half cheesboro fails. Then the safety cable would be the backup and stop the fixture from
falling to the ground. So do NOT fix the safety cable to the same place that the "C"clamp is attached.