elektraLite eyeBall RGBWA (5-in-1) - Manual (Page 8)

12. Settings.
(Set has several Sub Menus which allow the following functions to be used).
1). DIMMER
The Dimmer function allows different Dimmer curves to be chosen. There are 5 choices.
Choice 1 :- this is Dim off. The Dimmer curve is 0 which means any change in dimmer level is
instantaneous.
Choice 2:- Dim 1. The dimmer curve has the shortest fade in and fade out time.
Choice 3:- Dim 2. The dimmer curve has the 2
nd shortest fade in and fade out time.
Choice 4:- Dim 3. The dimmer curve has the 3 rd shortest fade in and fade out time
Choice 5:- Dim 4. The dimmer curve has the longest fade in and the fade out time.
To access the DIM function go through the Root Menu until DIMMER is found. Press Enter and then
use the ↑ or ↓ buttons to get to the DIM choice required.
Please note the DIM function under the Set menu in the fixture does not work when in the STAG mode.
When is STAG mode you can operate/access the DIM function directly through channel 10 on your
lighting controller.
2). RESET
This resets all values to their default.
Go through the Root Menu until Settings is displayed. Press Enter and then use the ↑ or ↓ buttons to
get to RESET. Press Enter. The display will have the cursor flashing across the bottom. The password
needs to be entered. The password is the following sequence using the ↑ and ↓ buttons.
↑ ↓ ↑ ↓ ↑ ↓ then press Enter once complete. The display will read OK followed by a return
to the RESET sub menu. The Menu button will need pressing to return to the Root Menu. Only once at
the Root Menu will the dmx control function once more. Please note the Reset also takes the dmx
address back to 001.
3).RGB to WHITE
The RGB to WHITE setting allows the ability to calibrate the white achieved when mixing RGBWA.
When RGB to WHITE is set to OFF, the output when Red, Green, Blue, White and Amber is at
maximum is 255 for all five colors. By definition this combination produces a white which may not be the
"blend" of white that cameras and other video equipment may want to "see".
When RGB is set to ON, the output can be white balanced to whatever looks good on camera. It also
serves to balance the white into a "warm" white which makes people look a lot better when they are in
the light!
See RGB to WHITE, for how to calibrate the white when the RGB to WHITE is turned ON.
To turn RGB either OFF or ON, go through the Root Menu until RGB to WHITE is found. Press Enter
and then use the ↑ or ↓ buttons to get to either OFF or ON. Once chosen, press Enter to save the
setting and then Menu to exit out back to the Root Menu.
4). DTV
The DTV setting allows the ability of the leds to not flicker when using video camera.
The choices are NTSC or PAL. NTSC is the USA system.
To set the DTV setting, go through the Root Menu until DV. Press Enter and then use the ↑ or↓ buttons
to get to either NTSC or PAL. Once chosen, press Enter to save the setting and the Menu to exit back
to the Root Menu.