elektraLite eyeBall RGBWA (5-in-1) - Manual (Page 9)

13. RGB to WHITE
When RGB to WHITE is turned on under the SETTINGS menu, then the RGB to WHITE calibration
can be done in the root menu. In fact it is a little bit misleading saying the RGB to white calibration
because in fact the eyeBall will allow you to calibrate white using all the "raw components"….meaning
RGBW and A. This gives the cameras and lighting designers the maximum palette to work with
regarding white balance.
To adjust the white balance, go through the Root Menu until RGB to white is reached. Then press
Enter. The screen will display RED at 255, use the ↑ or ↓ to set the Red component to the value
required. Press Enter to save and the screen will automatically advance to the value for GREEN (G255
for example). Again, use the ↑ or ↓ to make the adjustment you require for the Green leds. Press Enter
to save and the screen will automatically advance to the value of BLUE. Use the ↑ or ↓ to make the
adjustment you require for the Blue leds. Press Enter to save and the screen will automatically advance
to the value of White. Use the ↑ or ↓ to make the adjustment you require for the White leds. Press Enter
to save and the screen will automatically advance to the value of Amber. Use the ↑ or ↓ to make the
adjustment you require for the Amber leds. Press Enter to save and the screen will automatically
advance back to Red. At this stage, if happy with the calibration, press Menu to exit the RGB to WHITE
menu and return to the root menu.
14. Fans
There are several different control options for the fans.
Auto:- The fans come on when the temperature exceeds its pre-set value.
The fan turns off when the temperature falls below its pre-set value.
High:- The fans are constantly on at a high rotational speed.
Normal:- The fans are constantly on at their normal rotational speed.
Low:- The fans are constantly on at a lower than normal level. If the leds exceed their operational
pre-set temperature level, then the output is reduced as the fans are "locked" at lower rotational speed.
Off:- The fans are sent to be OFF. . If the leds exceed their operational pre-set temperature level, then
the output is reduced as the fans are "locked" OFF.
15. KEY LOCK
The Key function is an access password for the fixture. The KEY can be turned OFF or ON which then
deactivates or activates the password.
To set the KEY LOCK on, go through the Root Menu until KEY LOCK is found. Press Enter and use
the ↑ or ↓ to set the KEY LOCK to either OFF or ON. If the Key LOCK is turned ON then a password is
required to go into sensitive Menus and to change functions.
The password is ↑ ↓ ↑ ↓ ↑ ↓ (Up + Down + Up + Down + Up + Down) Enter.