elektraLite CP16/24 - Manual (Page 20)

19
SYSTEM PROGRAMMING
There are a number of features and settings for the CP16/24 that are to be programmed during installation that
seldom if ever need to be set again. They are generally used by the installer to customize the system to the
particular installation. These are all accessed using the "Menu" switch. Any menu selection that involves setting a
value will be stored in battery-backed memory.
Press "Menu" and the display will read:
MENU SELECT + -
AUDIO ON/OFF
Use the "+" and "-" keys to select from the different menu items. In the above display, audio enable is the
current selection. To select that item press "Enter". The display will go to the audio enable menu where you can
then set the audio enable to the desired value. You do not need to press "Enter" once a menu item is
programmed. You can press any other switch to continue. The various menu items are explained in the
following paragraphs.
Audio On/Off
The audio enable display reads:
AUDIO IS OFF
USE +/- TO SET
Use either the "+" or "-" key to toggle the audio on or off. When audio is on, chases will attempt to sync to the
beat of the audio signal. If there is no signal present the chase will not run. "AUD" will appear in the chase
display next to "BPM". Xfade is automatically set to 0 when a chase is controlled by audio. The audio sensitivity
can be adjusted from one of the following menu items.
Fixture Library
The fixture library display reads:
FIXTURE 01
GOLDENSCAN 2/3
Use the number keyswitches to select the fixture (01-16) then use the "+" and "-" keys to select from the fixture
library. You must set each of the 16 fixtures separately. This allows the CP16/24 to patch its faders and joystick
to match the selected fixture type.
Chapter
7