elektraLite CP16/24 - Manual (Page 22)

21
Pan Invert
The pan for a fixture can be inverted. The pan invert display reads:
FIXTURE 01 PAN
NORMAL
Use the number keyswitches to select the fixture number then use the "+" or "-" switch to toggle between
inverted or normal.
Tilt Invert
The tilt for a fixture can be inverted. The tilt invert display reads:
FIXTURE 01 TILT
NORMAL
Use the number keyswitches to select the fixture number then use the "+" or "-" switch to toggle between
inverted or normal.
Audio Level
The audio level display reads:
AUDIO IN SENSE 5
0-LEAST, 9-MOST
Select a value from (0-9) to control the sensitivity of the audio input, which is used to sync chase speed to audio.
The audio input is a line level input meant to be connected to the output of a preamp. In order to be effective
the music on this input must have some sort of pulsing beat to drive the chase. The sensitivity sets the trigger
level with 0 being the least sensitive and 9 being the most sensitive. If the audio source can be adjusted, leave
this setting at 5 and adjust at the source. If the signal can't be adjusted, try different settings until you get the best
results. A setting of 9 would be for very weak audio signals and a setting of 0 would be for strong signals.
MIDI Channel
The MIDI channel display reads:
MIDI CHANNEL 01
SELECT FROM 1-16
Use the keyswitches to select the MIDI channel (1-16) that the CP16/24 will send and receive on. Consult the
MIDI chapter for more information.