elektraLite CP16/24 - Manual (Page 6)

5
CUES
The CP16/24 allows you to store up to 225 cues in memory which can later be recalled directly using the
numbered keyswitches and Go switch or recalled in automatic sequences using chases and macros.
Programming Cues
To program a cue you must first create a "look" on stage. This is done by setting the control levels for each
fixture. You can do this one fixture at a time or in any group combination. To select the fixture(s) you want to
control, press "Fixture". The display will show the fixtures that are currently enabled
01 02 03 04 05
06 07 08
Use the numbered keyswitches to toggle fixtures on or off. You can enable any combination of fixtures. Use the
left arrow switch to switch between selecting fixtures 1-8 and 9-16. When selecting 9-16, switch 0 selects fixture
10, switch one selects fixture 11, and so on. When a fixture is disabled the faders and joystick will have no effect
but the fixture will still be controlled by cues or chases. Once a fixture is enabled you can control its pan and tilt
with the joystick or any of its other settings with the faders. The faders are used to control channels within the
fixture in ascending order. Use the right arrow switch to move from one fader bank to the next. This therefore
allows you access to channels higher than 6.
Bank 1 1ch 2ch 3ch 4ch 5ch 6ch
Bank 2 7ch 8ch 9ch 10ch 11ch 12ch
Bank 3 13ch 14ch 15ch 16ch 17ch 18ch
Bank 4 19ch 20ch 21ch 22ch 23ch 24ch
Chapter
3