elektraLite CP1 - Manual (Page 22)

product manual
model nº c p 1
# E_10051a
Elektralite
ELEKTRALITE CP-1 QUICK INSTRUCTIONS
Instruments must be set to the following addresses regardless of instrument type. For instruments 1-8 use addresses 1,
7, 13, 19, 25, 31, 37, 43.
To set inst. type on CP-1: press Enter / Scene / 998 / Enter. Use keypad to select inst., +/- to toggle type.
To select instruments to control or program: press Instrument / use keypad to select instruments desired. 0 key will
clear selections, any combination allowed, selection is maintained in battery memory.
To program scene: press black to clear all channels / select instruments / use joystick and faders to set up scene /
press Enter / Scene / assign number from 1 -200 / set crossfade time / Enter.
To call scene: press Scene / enter number from 1 -200 / Go. Next scene will automatically increment to next number.
You can press Go or enter a new number. If latch is on, scenes will pile on with latest takes precedence for each
instrument. Up to 3 separate long crossfades can occur simultaneously. In the unlikely event that 3 fades are in progress
the next call will happen without a fade. With latch off, scenes replace each other with unused instruments going to
black.
To edit scene: call scene / make any changes with joystick or faders / press Enter / Scene / use keypad to select same
or different location number / Enter.
To program chase: press Enter / Chase / use arrow keys to move cursor to “SCN” field / use keypad to enter scene
number / Enter / step will automatically advance / enter next scene number / after last entry (up to 99) press Enter /
cursor will return to Chase field / select chase number (1 -50) / set chase speed with speed fader / set cross fade if
desired (will default to 0) / Enter.
To call chase: press Chase / select chase number with keypad / Go. Chase speed and Xfade can be adjusted while
chase is running. If xfade is too long, chase step will not reach destination before next step call. If latch is on, up to 3
chases can run simultaneously, speed and xfade can only be adjusted for latest chase, chase steps will pile on with
latest takes precedence, after 3 chases are called any subsequent chase call will replace oldest chase. If audio is
present, programmed speed is overridden.
To edit chase: press Enter / Chase / select chase number with keypad / move cursor to step number / enter step
number to edit / move cursor to scene number / enter new scene number / Enter / repeat if desired. To save the edited
chase to memory you must move the cursor back to the chase number and press Enter. You can also enter a new
number and save it at a different location.
To erase a chase step: move cursor to step number / enter step number desired / press Delete. The step will be erased
and any higher steps will move down. You must always re-save the chase after editing it.
To insert a chase step: move cursor to step number / enter step number / press insert. A blank step will be inserted
and all higher steps will move up. You can only insert at a step that contains a scene, if the step is empty, nothing will
happen. You can then enter a new scene at this step. You must always re-save the chase after editing it.
To erase chase: press Enter / Chase / select chase number / Delete. You will be given a second chance to confirm or
abort erase.
To program macro: press Enter / Macro / move cursor under “SCN” / use any keypad switch to toggle between SCN
or CHS or you can press Black / Enter or use > + to get to next field / use keypad to select scene or chase number or
press Black. (Black will store a call to blackout using the current xfade slider position) / Enter / cursor will move to HOLD
field / use keypad to select hold time (1-999) seconds / Enter / repeat. After last step is entered press Enter or use < > to
move cursor to MACRO number field. Use keypad to select macro number (1-50) / Enter.