elektraLite CP1 - Manual (Page 6)

product manual
model nº c p 1
# E_10051a
Elektralite
NOTE: When a scene crossfades, only pan, tilt and iris actually fade as these are the only continuous type controls. All
other non-continuous type settings; color, gobos and strobe, snap to position at the end of the crossfade.
Editing Scenes
To edit an existing scene, first recall the scene as described in the previous paragraphs. Make any changes as
needed.using the control faders and joystick. Press “Enter”, “Scene”, then adjust the “Xfade” if desired. Select the scene
number using the keyswitches. You can write over the same scene number or you can select a different one if you are
copying this scene to another location. Finally press “Enter” to store the edited scene. If you are writing over the original
scene press “Enter” again when the display reads:
SCN 001 EXISTS,
ENTER OR CHANGE