elektraLite CP1 - Manual (Page 9)

product manual
model nº c p 1
# E_10051a
Elektralite
To delete steps from a chase, load the chase into the edit buffer as explained earlier. Select the step number that you
want to delete by moving the cursor under the step number in the display and selecting it. Press “Delete”. That step will
be deleted from the chase and any steps above that one will move down to the next lower step number. The display
will show that the scene that was at the next step has now moved down to the step that you just deleted. If the step you
deleted was the last step of the chase, the scene field will go blank showing that there is now no scene at this step.
Finally you must store the chase after you have edited it.
To insert a chase step into the middle of an existing chase, first load the chase into the edit buffer as explained earlier.
Call the step number where you want to insert the new step by moving the cursor under the step number and selecting
it. Press “Insert”. A blank step will be inserted at this step number and any steps above this one will be moved up one
step number. Move the cursor over to the scene number which will be blank. Select the scene number to insert at this
location then press “Enter”. The step number will automatically increment and you can insert another step by moving
the cursor back to the step number and repeating the previous operation. Finally you must store the chase once you are
finished editing.
To erase an entire chase from memory press “Enter” then “Chase”. Select the chase number then press “Delete”. The
display will read:
ERASE CHASE 01?
+ = YES, - = NO
Press the”+” key to confirm the erase or press”-” to escape.