elektraLite Elektrik Eye - Manual (Page 13)

-
１２ -
- Software version
This function displays the software version of the device.
1. Select
“VER” by pressing [UP] button.
2. Press [ENTER], the display shows “V-X.X”, “X.X“ stands for the version number, e.g. “V-1.0”,
“V-2.6”.
3. Press [ENTER] or [EXIT/DN] to return to the main menu.
- Main menu 3
1. Press [ENTER] for 3 seconds to enter the main menu (display flashing).
2. Press [UP] to select “ADJU”.
- Lamp adjustment
This function adjusts the lamp via the display panel. The shutter opens and the lamp can be adjusted. In this
mode, the device will not react to any control signal.
1. Select
“LADJ” by pressing [UP] button.
2. Press [ENTER], the display shows “ON” or “OFF”.
3. Press
[UP] to select “ON” to enable this function or “OFF” if you don’t.
4. Press [ENTER] to confirm.
5. Press [EXIT/DN] to return to the main menu.
- Test function of each channel
This function tests each channel on its (correct) function.
1. Select
“tESt” by pressing [UP] button.
2. Press [ENTER], the display shows “T-XX”, “X” stands for the channel number.
3.
The current channel will be tested.
4. Select the desired channel by pressing [UP] button.
5. Press [ENTER] or [EXIT/DN] to exit.
- Main menu 4
1. Press [ENTER] for 3 seconds to enter the main menu (display flashing).
2. Press [UP] to select “TIME”.
- Fixture running time
This function displays the running time of the device.
1. Select
“MATI” by pressing [UP] button.
2. Press [ENTER], the display shows “XXXX”, “X“ stands for the number of hours.