elektraLite Elektrik Eye - Manual (Page 2)

-
１ -
INTRODUCTION:
Thank you for choosing Elektralite’s Elektric Eye H.P. fixture.
Please read the User Manual carefully and keep it in a safe place after reading it.
The Elektric Eye is very easy to install and use once you have read the manual. Failure to do so could result in
damage to the fixture, which will not be covered under warranty so please take the time to read it.
When you unpack the Elektric Eye you should find inside the box: the fixture, a 120 volt power cable, a 3 pin
DMX signal cable, a safety cable and of course the CD with the manual. Please check carefully that there is no
damage caused by transportation. Should there be any, consult your dealer immediately and don’t install the
fixture.
Features
¾ Pan 630° / Tilt 265°
¾ 8 colors plus white & rainbow effect
¾ 6 rotating gobos
¾ Strobe : with a frequency of 0~10 flashes per second.
¾ Automatic program
¾ Display : digital address and function setting (also the display can be inverted if
fixture is hung upside down).
¾ High speed pan & tilt movements
¾ Local or remote resetting
¾ Lamp switch ON/OFF locally
¾ Auto test for all functions
¾ Value of each DMX-channel can be displayed
¾ Saved Program : You can edit and save a program internally in the fixture by using either the
display panel of the fixture or using an external controller (your
Elektralite CP10xt or CP20xt). You
can save a maximum of 48 scenes. You can then run this saved program by using the “run” feature
from the menu on the display panel
SAFETY INSTRUCTIONS
A Word of Caution.
Please remember you will be working with 120 volts and you can suffer electric shock from any exposed lives
wires. So please be careful at all times and behave wisely.
Now you’re Elektric Eye
left Elektralite’s factory in perfect condition. In order to maintain this condition and to
ensure a safe operation, it is absolutely essential that the installer and user follow the safety instructions and
warning notes written in this user manual. Remember any damage caused by disregarding the manual or not
reading it, will not be covered by warranty and Elektralite (or any of its dealers) will not accept responsibility for
any resulting damage or problems.
If the Elektric Eye has been exposed to large environmental temperature changes in transit please do not
switch it on immediately it is unpacked. There maybe internal condensation. So leave the Elektric Eye off until
it has reached the running temperature of the venue.
Elektralite’s Elektric Eye needs to be grounded. Do NOT cut the ground pin or try to use two-core cable to
connect it to a 120-volt receptacle. To be safe and to work properly you must have this fixture grounded.
A qualified electrician must do any electrical work.
Make sure that the power is only 120 volts. This unit will be damaged if you chose to install it at any other