Karcher IB 15-80 - Manual (Page 17)

- 6
1 Screw
2 Lower part
3 Nut
4 Disc
5 Filter inlay
6 Upper section
 Loosen 4 screws.
 Remove the lower part.
 Unscrew the nut.
 Remove the disc.
 Remove the filter inlay and replace it
with a new filter inlay.
 Reassemble the water separator in the
reverse sequence.
According to the specifications of BDV D
26, the following tests must be conducted
by a technical expert. The results of the
tests must be documented in a test report.
The device operator must carefully store
the test report until the next test.
 Check the device to see that it is in a
proper condition and is functioning well.
 Check the device to see that it is in a
proper condition, is functioning well and
has been installed properly.
 Check the device to see that it is in a
proper condition, is functioning well and
has been installed properly.
ƽ
Danger!
Risk of accident while working on the appli-
ance. Carry out all the steps described in
the chapter "Shut down" before starting
anhy work on the device.
ṇ
Warning
Risk of cold burns on account of dry ice or
cold parts of the machine. While working on
the machine, wear appropriate safety gear
for protection against cold or remove dry
ice and let the machine heat up.
Never put dry ice in your mouth.
Disconnecting the compressed air line from
the appliance during a power failure:

Remove side panel.
 Close the compressed air supply.
 Relieve the pressure by loosening the
drain screw on the bottom of the pres-
sure reducer.
1 Pressure reducer
 Disconnect the compressed air supply
line from the appliance.
Replacing the filter inlay in the water
separator attachment (accessory)
Tests
After a working break of more than one
year
After changing the installation site
The operational safety of the device
can get hampered on account of main-
tenance jobs or any modifications that
have been done.
Troubleshooting
Pressure release in case of power
failure
17 EN