Karcher KM 85-50 W P Adv - Manual (Page 22)

- 9
 Prepare the appliance and move it a
small distance forwards.
 Set the distance between the sealing
strip and the floor so that the bottom
edge trails behind at a distance of be-
tween 10 and 15 mm.
Note: If the setting range is not sufficient,
the sealing strip is worn off and should be
replaced.

Rear sealing strip
 Remove the waste container.
 Loosen the fastening screws of the
sealing strip.
 Replace the sealing strip.
 Tighten the fastening of the sealing
strip.
 Side sealing strips
 Loosen the fastening screws of the
sealing strip.
 Replace the sealing strip.
 Screw on new sealing strip without fully
tightening it.
 To set the floor clearance, insert a
sheet with a thickness of between 1 and
2 mm under the sealing strip.
 Adjust sealing strip.
 Tighten the fastening of the sealing
strip.
ṇ WARNING
Empty waste container before replacing
dust filter. Wear a dust mask when working
around the dust filter. Observe safety regu-
lations on the handling of fine particulate
material.

Lock parking brake.
 Remove the waste container.
 Remove the securing splint of the vibra-
tor bar.
 Pull out the bar.
 Unscrew the screws.
 Remove the tin frame.
 Replace the dust filter.
Note: Make sure when installing the new
filter that the fins are not damaged.
Replacing dust filter Accessories
Side brushes 6.905-626.0
With standard bristles for indoor and out-
door areas.
Side-brushes, soft
6.906-132.0
For fine dust on inside surfaces; wetness
resistant.
Hard side-brushes
6.905-625.0
For removing stubborn dirt in the external
area; resistant to moisture.
KM 85/50 W G
Standard sweep roller 6.906-509.0
Resistant of wear and moisture. Universal
bristles for inside and outside cleaning.
KM 85/50 W G Adv
Roller brush, pro
6.906-508.0
For professional applications, especially
safe against wear and tear.
Dust filter
5.731-585.0
Replace the flat-fold filter at least once a
year. Resistant to moisture, washable Fil-
ter effect > 99,9%, corresponds to catego-
ry C of ZH 1/487 of BIA.
22 EN