Sony TAV-L1 - Manual (Page 15)

Get
ting S
tar
te
d
15 GB
3: Connecting a TV aerial/VCR/DVD player
1
Remove the covers.
When all connections have been made, replace the
covers.
2
Connect your aerial to the socket on
the rear of the system.
If connecting to an aerial only
Go to step 4.
3
Connect your VCR/DVD player.
1 Connect the socket on the rear of the
system to the input socket on your VCR with
the RF lead.
2 Connect the scart socket on your VCR/DVD
player to the
/ 1 or 2 scart socket on
the rear of the system with a scart lead.
4
Connect the supplied AC power cord
(mains lead) to the AC IN socket on the
rear of the system.
Note
Do not connect the AC power cord (mains lead) to your
mains socket until all connections are complete.
To prevent the system from toppling over
Notes
• Be sure to take measures to prevent the system from
toppling over. If you fail to do so, the system may
topple over and cause injury. Anchor the system to a
wall, pillar, etc., to prevent it from toppling over.
• Any wall alternations (drilling, etc.) are your own
responsibility.
Prepare a commercially available strong rope or chain
and wall anchor bracket beforehand.
1
Remove the two small screws, and then
attach the two large screws to the screw
holes on the rear of the system.
Rear of the system
(SmartLink)
1 2 5
PC
IN
OUT
AC power cord
(mains lead)
(supplied)
Coaxial cable
(not supplied)
Scart lead (not supplied)
VCR
RF lead (not supplied)
DVD player
Scart lead (not supplied)
a
b
Continued