Sony CDP-XE200 - Manual (Page 10)

Playing CDs
10 EN
3
Press ENTER to select the track. Creating a program using the remote
(except for CDP-XE200)
Z
PROGRAM
CLEAR
1
Press PROGRAM before you start playing.
“PROGRAM” appears in the display.
2
Press number buttons of the tracks you want to
program in the order you want.
Example: To program the tracks 2, 8 and 5.
Press number buttons in the order 2, 8
and 5.
Number buttons
CHECK
>10
Last programmed track Playing order
After one second
Total playing time
If you’ve made a mistake
Press CLEAR, then repeat Steps 2 and 3.
4
Repeat Steps 2 and 3 to program the tracks in the
order you want.
5
Press · to start Program Play.
To cancel Program Play
Press PLAYMODE.
When tracks, which aren’t numerically consecutive on
the disc, are programmed consecutively (i.e. 1, 3, 5
etc.)
A one-second access time blank is added between the
tracks.
The program remains even after the Program Play
ends
When you press · , you can play the same program
again.
Notes
• The total playing time doesn’t appear in the display when it
exceeds 100 minutes.
• “FULL” appears in the display when you try to add a track
to a program which already contains 24 tracks.
(
Last programmed track Playing order
After one second
Total playing time
To select a track with a number over 10
Use >10 button (see page 8).
If you’ve made a mistake
Press CLEAR, then press the correct track number.
3
Press ( to start Program Play.
To cancel Program Play
Press CONTINUE.
When tracks, which aren’t numerically consecutive on
the disc, are programmed consecutively (i.e. 1, 3, 5
etc.)
A one-second access time blank is added between the
tracks.
Programmed tracks
Programmed tracks