Sony DRC-BT15 - Manual (Page 25)

DRC-BT15_U2 [US] 3-280-224-11(1)
25
US
, Check that the volume of the unit is
not set too low.
, Turn up the volume on the connected
device if necessary.
, Pair this unit and Bluetooth device
again (page 10).
Low sound level
, Turn up the volume of this unit.
, Turn up the volume on the connected
device if necessary.
Low sound quality
, Switch the Bluetooth connection to
A2DP (Advanced Audio Distribution
Profile) when HSP (Headset Profile)
is set.
Cannot make the Bluetooth
connection from Bluetooth
device to this unit.
, The Bluetooth device is not equipped
with SCMS-T content protection*.
With the unit turned off, press and
hold POWER and Nx for about 7
seconds to deactivate the SCMS-T
protection. The indicator (blue)
flashes once.
* The SCMS-T content protection
method is one of the methods to
protect the contents transmitted on
the Bluetooth wireless technology.
This unit can receive the contents
protected by this method. Press and
hold the POWER button and Nx
again for about 7 seconds to
reactivate the SCMS-T content
protection method on this unit. The
indicator (blue) flashes twice.
Sound skips frequently
during playback.
, Reception condition of this unit may
have become unstable due to
improper matching of the bit-rate
setting for the music transmitted from
the Bluetooth device and the
environment in which this unit is
used. *
1
Terminate A2DP Bluetooth
connection by operating the
Bluetooth device. While this unit is
turned on, press and hold Nx for
about 7 seconds to lower the setting
of receivable bit rate. *
2
* 1 Bit rate is a numerical value which
represents data transmission
volume per second. The higher the
bit rate, in general, the better
quality the sound will be. This unit
can receive high bit rate music but
sound skipping may occur
depending on the usage
environment.
* 2 When bit rate setting is completed,
the indicator (blue) flashes once.
The above operations may not
reduce the sound skip depending on
the usage environment. To reset to
the original setting, press and hold
Nx again for about 7 seconds.
The indicator (blue) flashes twice.
When calling
The recipient’s voice
cannot be heard.
, Check that both this unit and the
Bluetooth mobile phone are turned
on.
, Check the connection between this
unit and the Bluetooth mobile phone.
Make a Bluetooth connection (HFP
or HSP) again (page 17).
, Check that output of the Bluetooth
mobile phone is set for this unit.
, Check that the volume of the unit is
not set too low.
, Turn up the volume on the connected
Bluetooth mobile phone if necessary.
, If you are listening to music using
this unit, stop playback, press the
multi function button and talk.
Low sound from recipient
, Turn up the volume of this unit.
, Turn up the volume on the connected
Bluetooth mobile phone if necessary.
01US05ADD-BT15_U2.p65 23/10/07, 2:20 pm 25
Black