Sony PEG-NZ90 - Manual (Page 104)

104
Performing an IR HotSync
®
operation
Exchanging and updating data using a HotSync
®
operation
(Other HotSync
®
operations)
2
Click the HotSync icon in the Windows task tray once
again and select Setup from the shortcut menu.
The Setup dialog box is displayed.
3
Click the Local tab.
4
Adjust the following settings as needed.
• Serial port : Specifies a virtual port for an infrared port. If you are not
sure of the connection port, refer to the Infrared Monitor in the
Windows Control Panel .
• Speed : Determines the speed at which data is transferred. Try the As
Fast As Possible rate first, and adjust downward if you have any
problems.
5
Tap OK.
IR HotSync
®
operation is enabled.
Note
When performing a local HotSync
®
operation with the cradle, you need to restore the
local HotSync
®
settings. For details, refer to “To restore the local HotSync settings” on
page 105.