Sony PEG-NZ90 - Manual (Page 123)

123
Performing a HotSync
®
operation via LAN (LANSync)
Exchanging and updating data using a HotSync
®
operation
(Other HotSync
®
operations)
6
Tap OK.
The HotSync screen is displayed.
Performing a LANSync operation
You can perform a LANSync operation when you have prepared your
computer setting, CLIÉ handheld setting, and Conduit Setup. Turn on the
computers and start the HotSync
®
Manager application.
Note
To perform a LANSync operation, both computers connected to the cradle and
performing a HotSync
®
are required to be set for LANSync. On each computer, click the
HotSync icon in the Windows task tray (bottom right-hand corner of the taskbar)
and make sure that Network in the shortcut menu is selected. If not, click Network to
check it.
1
Rotate the Jog Dial™ navigator to select the HotSync icon
and press the Jog Dial™ navigator on the Application
Launcher screen.
The HotSync screen is displayed.
Tip
You can also tap the HotSync icon to display the HotSync screen.
2
Tap the HotSync icon.
A HotSync
®
operation starts.
The message will be displayed to note that the HotSync
®
operation is
complete.