Sony DCR-IP220 - Manual (Page 22)

22
Communicating with Bluetooth devices
(7) Enter the passkey.
For details on how to input characters, see “How to input characters” (p. 8).
For example, when using the BTA-NW1/BTA-NW1A Modem Adaptor with
Bluetooth Function, the passkey is its serial number which is indicated on the
label on the rear panel.
Tip on “Passkey”
The passkey is an identification number needed to allow two Bluetooth
devices to communicate with each other. The connection will be permitted
after entering the passkey. This “Passkey” is also referred to as a “Bluetooth
passkey”, “PIN”, “Bluetooth PIN”, etc. For details, refer to the operating
instructions supplied with your Bluetooth adaptor.
(8) Tap [Enter].
After the registration is completed, the Bluetooth Setup screen appears again.
“Bluetooth Registration Complete” message is displayed.
(9) Tap [OK].
The selected Bluetooth device is specified.
,
Note
When the message “Bluetooth Registration Error Check the Passkey” is
indicated, tap [OK]. Carry out the procedure again from step 4.
MODEM ADAPTOR WITH BLUETOOTH TM FUNCTION
MODEL NO. BTA-NW1 ®
Passkey
The number used when registering a
Bluetooth device