Speakers, Cd player – Sony MHC-RXD5 User Manual

Page 42

Advertising
background image

42

•The protective device on the amplifier has

been activated because of short circuit.
(“PROTECT” and “PUSH POWER” flash
alternately.) Turn off the unit, eliminate
the short-circuit problem and turn on the
power again.

•There is no audio output during timer

recording.

There is severe hum or noise.

•A TV or VCR is placed too close to the

stereo system. Move the stereo system
away from the TV or VCR.

The sound from the connected source is
distorted.

•If “VIDEO” appears in the display when

you press FUNCTION, switch the display
to “MD” (see “Note: Connecting a VCR”).

“0:00” (or “12:00”) flashes in the display.

•A power interruption occurred. Set the

clock and timer settings again.

The timer does not function.

•Set the clock correctly.

DAILY 1, DAILY 2, and REC do not appear
when you press the TIMER SELECT button.

•Set the timer correctly.
•Set the clock.

The remote does not function.

•There is an obstacle between the remote

and the system.

•The remote is not pointing in the

direction of the system’s sensor.

•The batteries have run down. Replace the

batteries.

There is acoustic feedback.

•Decrease the volume level.
•Move the microphone away form the

speakers or change the direction of the
microphone.

The color irregularity on a TV screen
persists.

•Turn off the TV set once, then turn it on

after 15 to 30 minutes. If the color
irregularity still persists, place the
speakers farther away from the TV set.

“PROTECT”and “PUSH POWER” appear
alternately.

•A strong signal was input. Press

to

turn off the power, leave the system
turned off for a while, then press
again to turn on the power.

Speakers

Sound comes from one channel or
unbalanced left and right volume.

•Check the speaker connection and

speaker placement.

Sound lacks bass.

•Check that the speaker’s + and – jacks are

connected correctly.

CD Player

The CD tray does not close.

•The CD is not placed properly.

The CD will not play.

•The CD is not lying flat in the disc tray.
•The CD is dirty.
•The CD is inserted label side down.
•Moisture condensation has built up.

Remove the CD and leave the system
turned on for about an hour until the
moisture evaporates.

Play does not start from the first track.

•The player is in program or shuffle mode.

Press PLAY MODE repeatedly until
“PROGRAM” or “SHUFFLE” disappears.

“OVER” is displayed.

•You have reached the end of the CD.

Press and hold

0 to return.

Troubleshooting (continued)

Advertising