Sony PCV-RX770 - Manual (Page 75)

To Install Memory
The preinstalled memory configuration may vary, depending on the computer you purchased. Your computer may ship with
all available memory slots filled. See the online specifications sheet for details about the amount of memory installed in your
computer. For memory replacement or upgrades, use only 2.5 V, 64-bit, PC2100 DDR-SDRAM Dual InLine Memory Modules
(DIMM).
You can purchase additional memory modules, accessories, and peripheral equipment from your local retailer.
Observe the proper safety precautions when you add or remove memory in your Sony computer. See Before
you upgrade your computer .
Removing memory
1. Shut down your computer and turn off all peripheral devices, such as your printer.
2. Unplug your computer and any peripheral devices.
3. Remove the side panel. See Removing the side panel .
4. Gently place the unit on its side. If necessary, remove any cables, add-on cards, or other components to access
the DIMM slots.
5. Locate the memory module(s) you wish to remove.
6. Push down on the handles located on both sides of the module to eject it from the slot.
7. Grasp one edge of the module and lift it out. Store the module in a static-free bag.
Rem ov ing/Installing m em ory
Installing memory
1. Shut down your computer and turn off all peripheral devices, such as your printer.
2. Unplug your computer and any peripheral devices.
3. Remove the side panel. See Removing the side panel .
4. Gently place the unit on its side. If necessary, remove any cables, add-on cards, or other components to access
the DIMM slots.
Remove the power supply before installing the memory module(s), by following these steps:
Page 75