Sony LF-B10 - Manual (Page 19)

The fe
atur
e
s
of the
B
a
se Station
19
The features of the Base Station
Automatic NetAV check tests the settings of your
Base Station and your router to see if
LocationFree devices can connect to the Base
Station via the Internet.
When you turn your Base Station on, the SETUP
MODE/NET AV LED starts blinking green, and
then the automatic NetAV check starts. If the
SETUP MODE/NET AV LED goes off, the test
has finished successfully.
If the SETUP MODE/NET AV LED starts
blinking amber, the check has failed. In this case,
open the [Base Station Settings] page and
perform NetAV check manually to check the
cause of the problem. (
1 page 22)
Automatic NetAV check starts when the Base
Station is turned on. Also, it starts at regular
intervals.
With LocationFree Player LFA-PC20, the Base
Station can learn signals of the remote of a video
device to control the device with the on-screen
remote control. For more details, refer to
“Configuring the LocationFree Player” in “Part
2: LocationFree Player”.
When you make settings of the on-screen remote
control with LocationFree Player LFA-PC20, you
can search the remote control data of your device
from the list of the available models by sending
out the signal from the remote of your device to
the Base Station. For more details, refer to
“Configuring the LocationFree Player” in “Part
2: LocationFree Player”.
Automatic NetAV
check Receiving remote
signals
Learning remote control
Searching remote control
data