Sony LF-B10 - Manual (Page 57)

Confi
guring
the
Loca
tionF
ree Pl
a
y
er
17
After selecting the make, types appear in the
list.
4
Click [Power on/off] to check to see if the
selection is correct.
If the configuration is correct, each time you
click [Power on/off], you can turn on or off
your device. If it does not work, make sure
that the make and type are correct and the IR
blaster is correctly placed in front of the
remote sensor of the connected video device.
z Tip
You can check the setting only while connected to
the Base Station.
5
Click [OK].
Selecting the on-screen remote
control using the remote of your
device
If your Base Station is LF-B20/LF-B10, you can
search the remote control by sending the signal of
the remote of your external device to your Base
Station. Ready the remote of your device, and
follow the instructions below to search the remote
control.
Note
You can search the remote control while connecting to
the Base Station.
3
At Step 3 of "Selecting the on-screen remote
control manually", click [Search].
The screen appears and indicates the standby
status for the signal of the remote.
4
Point the remote of the device to the IR
Receiver of the Base Station, and then press
some buttons on the remote one by one.
A list of manufactures and models appears.
Each time the Base Station receives a remote
code, the list is revised.