Sony LF-B10 - Manual (Page 59)

Confi
guring
the
Loca
tionF
ree Pl
a
y
er
19
5
Click [Learn].
The learning remote screen and the remote
control panel appear.
6
Select a button on the remote control panel
you want to learn the device's remote control
signal to.
The screen appears and indicates the standby
status for the signal of the remote.
If you select a button such as “Button 1”, you
can edit the button’s name. After entering a
new name and clicking [OK], the standby
status screen appears.
7
Point the remote of the device to the IR
Receiver on the Base Station, and then press
the button on the remote you want to learn.
When the remote code has been learned, the
message disappears and a red frame is
displayed around the button.
Notes
• Point the remote at the IR Receiver of the Base
Station from a distance about 1 to 2 inches.
• Keep pressing the button until the screen
disappears. Take care not to move the remote
while pressing the button.
• If the Base Station does not receive the signal
from your remote control, try replacing the
battery cell of the remote control.