Sony NEX-VG30H - Manual (Page 73)


Table of C
on
ten
ts
Sear
ch image
Inde
x
US
(Miniature)
Creates an image which enhances the subject
vividly, with the background defocused
considerably. This effect may often be found
in pictures of miniature models. The focus on
other areas is greatly reduced.
Notes
When [ RAW/JPEG] is set to [RAW] or
[RAW & JPEG], Picture Effect cannot be used.
When you shoot movies, [Soft Focus] and
[Miniature] effects are not available.
Cinematone
The camcorder automatically adjusts
the color of the movie to resemble the
atmosphere of film camera images when
recording a movie.
 Off
Does not use the Cinematone function.
On
Uses the Cinematone function.
Notes
When you switch the [ Cinematone]
function on or off, the image will be paused
temporarily.
You cannot use the face detection function
when [ Cinematone] is set to [On].
Self-Timer
Press PHOTO to start the count down. A
photo is recorded after about 10 seconds.
 Off
Cancels the self-timer.
On ( )
Starts the self-timer recording. To cancel the
recording, touch .
Tips
You can also operate by pressing PHOTO on
the Wireless Remote Commander (p. 112).








Drive Mode
You can set the drive mode, such as
continuous or bracket shooting. This item
is available in still image recording mode
only.
 Single Shooting
Shoots 1 still image. Normal shooting mode.
Cont. Shooting ( )
Shoots images continuously at high speed
while you press and hold down PHOTO.
Focus and brightness settings of the first shot
are used for the following shots.
Bracket: 0.3 EV ( )
Takes three photos, with different EV settings,
each of which differs by 0.3 EV.
Bracket: 0.7 EV ( )
Takes three photos, with different EV settings,
each of which differs by 0.7 EV.
Notes
[Single Shooting] is always set when using
the PHOTO button on the Wireless Remote
Commander for shooting. Note that shooting
may not be possible if it is difficult to focus on
a subject.
AF Mode
Selects the focus method when PHOTO is
pressed.
This item is available in still image
recording mode only.
 Single-shot ( )
The camcorder focuses and the focus is
locked when you press PHOTO halfway
down. Use this when the subject is
motionless.
Continuous ( )
The camcorder continues to focus while
PHOTO is pressed and held halfway down.
Use this when the subject is in motion.

