Sony HCD-EX5 - Manual (Page 10)

10 GB
Programing CD tracks
— Program Play
You can make a program of up to 25 tracks on
a CD in the order you want to play them.
1
Press FUNCTION repeatedly to switch
the function to CD.
2
Press PLAY MODE on the remote in
stop mode repeatedly until
“PROGRAM” appears.
3
Press . or > repeatedly until the
desired track number appears.
Stop play Press x.
Pause Press NX (or X on the remote).
Press again to resume play.
Select a track During play or pause, press .
or > repeatedly until you find
the desired track.
Find a point in
a track During play, press and hold down
m or M and release it at the
desired point.
Play repeatedly
(Repeat Play) Press REPEAT on the remote
repeatedly during play until
“REPEAT” or “REPEAT1”
appears.
REPEAT: For all the tracks on the
CD up to five times.
REPEAT1: For a single track only.
To cancel playing repeatedly, press
REPEAT on the remote repeatedly
until “REPEAT” and “REPEAT1”
disappear.
Remove the CD Press Z to remove the CD, then
press Z again to close the cover
inside the disc slot.
To enter track number using the
remote
You can also select the desired track using the
remote during Normal Play (no display).
Press number buttons. Play automatically
starts.
To enter track number 10 or higher
1 Press >10.
2 Enter the corresponding digits.
To enter 0, press 10/0 instead.
Example:
To enter track number 30, press >10, then 3 and 10/0.
Selected track
number Playing time of the
selected track
4
Press ENTER/YES on the remote.
The track is programed.
“Step” appears, followed by the order
number of the track just programed. Then
the last programed track number appears,
followed by the total playing time of the
program.
If you made a mistake, you can clear the last
programed track from the program by
pressing CLEAR on the remote.
Last programed
track number Total playing
time
5
To program additional tracks, repeat
steps 3 and 4.
6
Press NX (or CD N on the remote).
Playing a CD (continued)
Other operations
To Do this