Sony DSC-G3 - Manual (Page 159)

Ta
ble
of
co
nte
n
ts
Op
e
rat
io
n
S
ear
ch
HO
M
E
/MENU
Se
ar
ch
In
de
x
159 GB
Cannot print images.
• Check that the camera and the printer are properly connected using the cable for multi-use terminal.
• Turn on the printer. For details, refer to the operating instructions supplied with the printer.
• If you select [Exit] during printing, images may not be printed. Disconnect and connect the cable for
multi-use terminal again. If you still cannot print your images, disconnect the cable for multi-use
terminal, turn the printer off and then on, then connect the cable for multi-use terminal again.
• Movies cannot be printed.
• Images shot using other cameras, or images modified with a computer may not be printed.
Printing is canceled.
• Confirm that you have disconnected the cable for multi-use terminal before the (PictBridge
Connecting) mark disappears.
Cannot insert the date or print images in the index mode.
• The printer does not provide these functions. Consult the printer manufacturer as to whether the
printer provides these functions or not.
• The date may not be inserted in the index mode depending on the printer. Consult the printer
manufacturer.
“---- -- --” is printed on the date-inserted part of the image.
• The image does not have the recording data so the date cannot be inserted. Set [Date] to [Off] and
print the image again (page 148).
Cannot select the print size.
• Consult the printer manufacturer as to whether the printer can provide the desired size.
Cannot print the image at the size selected.
• When you use paper of a different size after connecting the printer to the camera, disconnect and then
reconnect the cable for multi-use terminal.
• The print setting of the camera differs from that of the printer. Change the setting of either the camera
(page 148) or the printer.
Cannot operate the camera after canceling printing.
• Wait for a while as the printer is carrying out the cancellation. It may take some time depending on
the printer.
Cannot operate the touch panel buttons correctly or fully.
• Perform [Calibration] (page 60).
The paint pen operation reacts at inappropriate points.
• Perform [Calibration] (page 60).
Touch panel