Sony DCR-TRV20 - Manual (Page 11)

11
Getting started
Charging the battery pack
Use the battery pack after charging it for your camcorder.
Your camcorder operates only with the “InfoLITHIUM” battery pack (M series).
(1) Open the DC IN jack cover, pulling the cover out a little and rotating. Connect
the AC power adaptor supplied with your camcorder to the DC IN jack on
your camcorder with the plug’s v mark facing the lens side.
(2) Connect the power cord to the AC power adaptor.
(3) Connect the power cord to the wall outlet.
(4) Set the POWER switch to OFF (CHG). Charging begins. The remaining battery
time is indicated in minutes on the display window.
When the remaining battery indicator changes to , normal charge is completed. To
fully charge the battery (full charge), leave the battery pack attached for about one hour
after normal charge is completed until FULL appears in the display window. Fully
charging the battery allows you to use the battery longer than usual.
After charging the battery pack
Disconnect the AC power adaptor from the DC IN jack on your camcorder.
Notes
•Prevent metallic objects from coming into contact with the metal parts of the DC plug
of the AC power adaptor. This may cause a short-circuit, damaging the AC power
adaptor.
•Keep the battery pack dry.
•When the battery pack is not to be used for a long time, charge the battery pack once
fully and then use it until it fully discharges again. Keep the battery pack in a cool
place.
Remaining battery time indicator
The remaining battery time you record with the viewfinder is displayed.
The remaining battery time indicator in the display window roughly indicates the
recording time with the viewfinder.
Battery pack
The battery pack is charged a little before it leaves the factory.
Step 1 Preparing the power supply
2
1
4
VCR
OFF
(CHG
)
MEMORY
CAMERA
POWER