Sony DCR-TRV20 - Manual (Page 24)

24
You can use these buttons to check the recorded picture or shoot so that the transition
between the last recorded scene and the next scene you record is smooth.
END SEARCH
You can go to the end of the recorded section after you record.
Press END SEARCH in the standby mode.
The last five seconds of the recorded section are played back and playback stops. You
can monitor the sound from the speaker or headphones.
EDITSEARCH
You can search for the next recording start point.
Hold down the +/– 7 side of EDITSEARCH in the standby mode. The recorded section
is played back.
+ : to go forward
– 7: to go backward
Release EDITSEARCH to stop playback. If you press START/STOP, re-recording begins
from the point you released EDITSEARCH. You cannot monitor the sound.
Rec Review
You can check the last recorded section.
Press the – 7 side of EDITSEARCH momentarily in the standby mode.
The last few seconds of the selected section are played back. You can monitor the sound
from the speaker or headphones.
End search function
When you use a tape without cassette memory, the end search function does not work
once you eject the cassette after you have recorded on the tape. If you use a tape with
cassette memory, the end search function works even once you eject the cassette.
If there is a blank portion in the recorded portion, the end search function may not work
correctly (p. 124).
Checking the recording
– END SEARCH / EDITSEARCH /
Rec Review
EDITSEARCH
END SEARCH