Closing the server – Apple ATA Controller Board User Manual
Page 7
Xserve ATA Controller Board -
7
2.
Reinstall the two ATA controller clips.
(Figure 6)
Note:
When replacing the ATA controller board clips, orient them so that the long end of
each clip points away from the middle of the server. Place the inside edge of the clip into
the small notch and then snap down the outer edge of the clip.
Figure 6
3.
If you disconnected it earlier, reconnect the blower cable nearest the ATA controller
board.
4.
If necessary, replace the heatsink duct on the heatsink.
Closing the Server
1.
Carefully slide the bottom housing back into the rack.
2.
Tighten the front thumbscrews to secure it.
Warning: Never turn on the server unless all of its internal and external parts
are in place and it is closed. Operating the server when it is open or missing
parts can damage it or cause injury.