Sony HT-6600DP - Manual (Page 35)

Other Operations
35
US
HT-6600DP 4-244-560-11(1) US
Adjustments using the
SET UP menu
The SET UP menu allows you to make the
following adjustments.
1
Press MAIN MENU repeatedly to select
“ SET UP ”.
2
Press or to select the parameter
you want to adjust.
3
Turn the jog dial to select the setting
you want.
The setting is entered automatically.
Initial settings
Parameter Initial setting
DEC. XXXX PCM (for DVD,
CD/SACD and
MD/TAPE),
AUTO (for VIDEO 2)
x Decode priority (DEC. XXXX)
Sets the appropriate decoding for incoming
digital signals.
• PCM priority mode (DEC. PCM)
Use to enjoy playback from audio CD
(PCM), DVD and MD. When used with
media other than CD, DVD or MD, you may
experience noise. If this happens, switch to
AUTO mode.
• AUTO mode (DEC. AUTO)
Use to enjoy playback from audio CD
(PCM), DVD, DTS-CD and DTS-LD
sources. However, with audio CDs, you may
not be able to listen the very first moments
of each track.
Normally, use as-is with the initial settings
above.
Changing the command
mode of the receiver
This function is useful when you use 2 Sony
receivers in the same room.
1
Turn off the receiver.
2
Hold down ENTER and press 1/u to
turn on the receiver.
“C.MODE.AVX” appears in the display.
Each time you repeat the procedure above,
the display changes as follows:
C.MODE.AV1
y C.MODE.AV2
Tip
The initial setting is “C.MODE.AV2”.
Notes
• The initial setting for the command mode of the
supplied remote is “AV2”.
• If the command mode of the receiver and the
remote is different, you cannot use the remote to
operate the receiver.