Sony ICD-LX30 - Manual (Page 52)

52 GB
Message List
Message Cause/Remedy
HOLD.
Slide HOLD Switch to
Activate. • All the button operations are disabled because the memory
card recorder is in the HOLD status to prevent unintentional
operations. Slide the HOLD•POWER switch towards the
center to release the memory card recorder from the HOLD
status (page 10).
Low Battery • The batteries are exhausted. Replace the old LR03 (size
AAA) alkaline batteries with new ones (page 11).
Memory Card Error • An error occurred while a memory card was being inserted
into the memory card slot. Remove and try inserting it again.
If this message persists, use a new memory card.
Memory Card Not
Supported • A memory card that the memory card recorder does not
support is inserted. See “About compatible memory cards” on
page 15.
Memory Card Locked • The memory card is write-protected. A write-protected
memory card cannot be used with the memory card recorder.
Read Only Memory Card • A read-only memory card is inserted. A read-only memory
card cannot be used with the memory card recorder.
Memory Full • The remaining memory capacity of the memory card recorder
is insufficient. Erase unnecessary files (page 33), and then
perform “Re-Sort by Date,” or insert a new memory card.