Sony STR-DH540 - Manual (Page 59)

59 GB
A
d
ju
s
tin
g Se
tt
in
g
s
x Auto Volume
This receiver can adjust the volume
automatically depending on the input
signal or content from the connected
equipment.
This function is useful, for example, when
the sound of a commercial is louder than
the TV programs.
• On
• Off
• Be sure to reduce the volume level before you
turn on/off this function.
• As this function is available only when Dolby
Digital, DTS or Linear PCM signals are input,
the sound may suddenly increase when you
switch to other formats.
• This function does not work in the following
cases.
– Linear PCM signals with a sampling
frequency of more than 48 kHz are being
received.
– Dolby Digital Plus, Dolby TrueHD, DTS
96/24, DTS-HD Master Audio, or DTS-HD
High Resolution Audio signals are being
received.
x Dual Mono (Digital broadcast
language selection)
Lets you select the language you want
when you listen to the dual audio of a
digital broadcast when available. This
feature only functions for Dolby Digital
sources.
• Main/Sub: Sound of the main language
will be output through the front left
speaker and sound of the sub language
will be output through the front right
speaker simultaneously.
• Main: Sound of the main language will
be output.
• Sub: Sound of the sub language will be
output.
x D.Range Comp. (Dynamic
Range Compression)
Lets you compress the dynamic range of
the soundtrack. This may be useful when
you want to watch movies at low volumes
late at night. Dynamic range compression
is possible with Dolby Digital sources only.
• On: The dynamic range is compressed as
intended by the recording engineer.
• Auto: The dynamic range is compressed
automatically.
• Off: The dynamic range is not
compressed.
HDMI Settings menu
You can adjust the required settings for
equipment connected to the HDMI jack.
x Control for HDMI
Lets you turn the Control for HDMI
function on or off. For details, see
“Preparing for the “BRAVIA” Sync”
(page 47).
• On
• Off
• When you set “Control for HDMI” to “On”,
“HDMI Audio Out” may be changed
automatically.
• When the receiver is in standby mode, the ? /1
indicator on the front panel lights up in amber if
“Control for HDMI” is set to “On”.
Notes
Notes