Sony RHT-G800 - Manual (Page 29)

29 US
Ad
v
a
n
ce
d Se
ttings
If you connect a Sony TV, follow the steps below
to program the remote. The TV input will be
selected automatically (Input SYNC).
• Do not use the HDMI control function while the Input
SYNC function is active.
For details, see the HDMI CONRTOL Guide of the
stand.
1
Press TV (orange) while holding down
the input button (TV, DVD/BD, SAT,
AUDIO) for the component you want to
operate.
For example, if you are going to operate a
DVD player, press DVD/BD.
The input button you pressed flashes.
2
Check the table below for the remote
button number corresponding to the TV
input jack you have connected to, and
press the number.
The input button (TV, DVD/BD, SAT,
AUDIO) goes off when you press the
number button.
* TV input jack name may differ depending on
your TV model.
• Press 20 if you do not want to send signals to the
TV.
3
Press ENT.
The setting is completed after the input
button you pressed in step 1 flashes twice.
4
Repeat steps 1 to 3 to program the
remote.
• An error has occurred when the input button you
pressed in step 1 flashes five times. Perform this
process from step 1 again.
• The two digits entered last are valid.
Advanced Settings
Programming the remote
for TV operation (Input
SYNC: Sony TV only)
Note
S
L
O
O
T
U N E M
S
N
OI
T
P O
G
U
ID
E
DIS
P
L
A
Y
E M O H
N
R
U
T
E
R
Number
buttons
TV
(orange)
Input
buttons
(TV, DVD/
BD, SAT,
AUDIO)
ENT
TV input jack* Remote Button
(codes)
VIDEO 1 21
VIDEO 2 22
VIDEO 3 23
VIDEO 4 24
VIDEO 5 25
VIDEO 6 26
VIDEO 7 27
VIDEO 8 28
COMPONENT 1 29
COMPONENT 2 30
COMPONENT 3 31
COMPONENT 4 32
HDMI 1 33
HDMI 2 34
HDMI 3 35
HDMI 4 36
HDMI 5 37
VIDEO RESET (TV) 38
NONE 20
Tip
Notes
continued