Sony MHC-NX3AV - Manual (Page 11)

11
TUNED
STEREO
– +
0
g
)
≠ + – +
POWER SAVE/DEMO
(STANDBY)
DISPLAY
To tune in a station with a weak
signal
Press + or – repeatedly in step 2 to tune in the
station manually.
To set another station to the exist
preset number
Start over from step 1. After step 3, turn the
jog dial to select the preset number you want
to store the other station.
You can add a new preset number after the
last preset number.
To erase a preset station
1 Keep pressing TUNER MEMORY until a
preset number flashes in the display.
2 Turn the jog dial to select the preset
number you want to erase.
Select “ALL ERASE” when you want to
erase all the preset stations.
3 Press ENTER.
“COMPLETE!!” appears.
When you erase a preset number, the preset
number decreases by one and all preset
numbers following the erased one are
renumbered.
To change the AM tuning interval
(Except for European and Middle
Eastern models)
The AM tuning interval is factory set to 9 kHz
(10 kHz in some areas). To change the AM tuning
interval, tune in any AM station first, then turn off
the power. While holding down the TUNER
MEMORY, press
1/u to turn the power back on.
When you change the interval, AM preset stations
will be erased. To reset the interval, repeat the same
procedure.
Tip
The preset stations are retained for half a day even if
you unplug the power cord or if a power failure
occurs.
Saving the power in
standby mode
(U.S.A., Canadian and European
models only)
You can lower the power consumption to a
minimum (Power Saving Mode) and save
energy in the standby mode.
/ Press POWER SAVE/DEMO
(STANDBY) when the power is off.
The system switches to the Power Saving
Mode and the clock display disappears.
The system is powering on/off by
pressing
1/u.
Tips
• Each time you press POWER SAVE/DEMO
(STANDBY) in the Power Saving Mode, the
display switches between the Power Saving Mode
and the demo mode.
• 1/u indicator and timer indicator (when the timer
is set) light up even in the Power Saving Mode.
• The timer works in the Power Saving Mode.
Notes
• You cannot set the time in the Power Saving
Mode.
• One Touch Play function does not work in the
Power Saving Mode.
To cancel the Power Saving Mode
Press DISPLAY.
The clock display appears.
1/u
(Power)