Sony HCD-GX40 - Manual (Page 14)

14 GB
Setting presets through
manual tuning
1
Press TUNER/BAND repeatedly to
select “FM” or “AM”.
2
Press m or M (or TUNING – or + on
the remote) repeatedly to tune in the
desired station.
3
Press TUNER MEMORY on the remote.
A preset number appears in the display.
The stations are stored from preset number
1.
4
Press . or > (or PRESET – or +
on the remote) repeatedly to select the
desired preset number.
5
Press ENTER on the remote.
6
Repeat steps 1 to 5 to store other
stations.
Presetting radio stations (continued) Other Operations
To Do this
Follow the procedure described in
“Setting presets through manual
tuning”.
Start over from step 1. After step
3, press . or > (or PRESET
– or + on the remote) repeatedly to
select the preset number you want
to store the other station.
To change the AM tuning interval
(except for the European and Middle
Eastern models)
The AM tuning interval is factory-set to 9 kHz
(10 kHz in some areas). To change the AM
tuning interval, tune in any AM station first,
then turn off the system. While holding down
TUNER/BAND, turn the system back on.
When you change the interval, all the AM
preset stations are erased. To reset the interval,
repeat the same procedure.
Note
You cannot change the AM tuning interval in the
Power Saving Mode.
Tips
• The preset stations are retained for half a day even
if you disconnect the mains lead or if a power
failure occurs.
• To improve broadcast reception, reorient or move
the supplied antenna near a window or outdoors.
Tune in a station
with a weak
signal
Set another
station to an
existing preset
number