Sony RCD-W10 - Manual (Page 20)

20
Turn on the indicator
OPTICAL
ANALOG
Recording on a CD-R or
CD-RW Manually
You can start recording from the end of the
existing material. Before recording, see “Notes
on Recording” on page 16.
When using the remote, set SELECT to CDR.
• After recording, you must finalize the disc.
Until the disc is properly finalized, it cannot
be played on any other machine. See
“Finalizing a CD-R or CD-RW” on page 24.
1
Turn on the amplifier and the sound
source, and then select the sound
source on the amplifier.
2
Press OPEN/CLOSE of DECK B and
place a recordable CD-R or CD-RW on
DECK B.
Press OPEN/CLOSE again to close the
disc tray.
REC z
INPUT
H
REC z
H
INPUT
SELECT
3
Press INPUT repeatedly to select the
input connector.
To record through
DIGITAL OPTICAL IN
ANALOG IN
To record the disc in DECK A, turn off
“OPTICAL” or “ANALOG.”
4
Press REC z .
DECK B stands by for recording.
5
Adjust the recording level, if necessary.
For details, see “Adjusting the Recording
Level” on page 21.
6
Press H .
7
Start playing the sound source you
want to record.
To pause recording
Press X. To resume recording, press the button
again or press H.
Note
Whenever you pause recording, a new track number
is added. For example, if you paused recording while
recording on track 4, the track number increases by
one and recording continues on the new track when
recording is resumed.
To stop recording
Press x.
“PMA Writing” appears while updating the
information of the disc before stopping the
recording.
Notes
• If you press REC z during recording, you can add
a track (page 22). The track must be longer than 4
seconds.
• This unit uses the Serial Copy Management System,
which allows only first-generation digital copies to
be made of premastered software via the unit’s
digital input. Therefore you may not be able to
record a CD-R or CD-RW digitally through
OPTICAL IN, depending on the content being
recorded.
OPEN/CLOSE
x
x X
X
With the label side up