Sony DHC-MD515 - Manual (Page 46)

46
Labeling an MD
— Name Function
You can create titles (names) for your
recorded MDs and tracks. About 1,700
characters can be memorized for each MD.
1
Insert an MD you want to edit (see
page 18).
2
Press the MD button to switch the
function to MD.
3
Press p to stop playing.
Make sure that the total number of
tracks and the playing time appear in the
display, then go to the next step.
To label a track, turn MULTI JOG until
the desired track number appears.
4
Press EDIT/NO, then turn MULTI
JOG until “MD Name in ?” appears.
5
Press ENTER/YES.
The cursor starts flashing.
2 3 4 5,10 6
4,7 8 CURSOR N
6
Press DISPLAY repeatedly until the
type of character you want appears.
Each time you press the button, the
display changes as follows:
A (Upper case) n a (Lower case) n 0
(Numbers) n ! (Symbols)* n
(Space)
n A…
*You can use the following symbols.
7
Turn MULTI JOG until the desired
character appears.
To enter a blank space, go to the next
step without turning MULTI JOG. A
blank space cannot be entered in the first
position.
8
Press CURSOR n.
The character you selected in step 7 stops
flashing and the cursor shifts to the right.
9
Repeat steps 6 through 8 to
complete the entire title.
If you make a mistake, press CURSOR
N
or n until the character you want to
change flashes, then repeat steps 6
through 8. To erase a character, press
EDIT/NO. Each time you press the
button, the character in the cursor
position is erased. You cannot insert a
character between previously input
characters.
10
Press ENTER/YES to complete the
labeling procedure.
The titles you labeled appear
sequentially and the display returns to
the original indication after a while.
!"#$%&'()
∗
+,–./:;<=>?@_`
1 2 3
LEVEL SYNC -
DISC
ALL DISCS
Nam ? e n i MD
1 2 3
LEVEL SYNC -
DISC
ALL DISCS
D1 M
1 2 3
LEVEL SYNC -
DISC
ALL DISCS
D1 M A
DISC SKIP
TAPE